Fabber

How many good parts?

A traveler that counts, times and checks as the work happens

Operators open the job pack on a tablet at the machine. It shows the approved drawing, the operations in order, the setup notes from last time and the checklist. Timers and counts go straight onto the job, so the office knows what's done without walking the floor.

Set up your shop
BRK-100 · Motor bracketJ-1042
10Mill
20Deburr
30Anodize
40Inspect
Stop hands-on 0:42 Start setup
Good
32
Scrap
1
Reached it
33

Checklist

Slot width 6.00–6.05 accept 6–6.056.03 Pass

Timers that know machine time from labor

Setup, machine run and hands-on time are separate timers. An unattended cycle isn't costed at an operator's wage, and a forgotten timer shows up on Today before it ruins the job's cost.

  • Several people can work one operation
  • Hours can be entered by hand for the shift that forgot
  • Timers stop on their own when a job is held or completed

Counts that follow the parts

Good, scrap and rework are counted per operation. A step can't count more parts than came off the one before it, and scrap needs a reason. Shipping is capped at the good parts made.

Checklists that judge the measurement

Write the tolerance into the checklist item ("Bore 12.00 ±0.02", ".500 +.000/-.002", "Ra 1.6 max") and the operator types what they measured. Fabber says pass or fail, and the reading goes on the inspection report.

Shared tablets, QR travelers, no paper

Set a tablet up as a floor station: operators tap their name and a PIN, and it signs them out when they walk away. Printed travelers carry a QR code that opens the right job pack.

  • Operators see the work, never prices or costs
  • "Something's blocking this" and "Parts don't meet the drawing" are one tap away
  • Outside processing is sent and received from the job pack

Questions

Does it need special hardware?
No. Any tablet, phone or PC with a current browser works. Many shops put a cheap Android tablet or an iPad at each machine or one per cell.
Can operators share one tablet?
Yes. A manager registers it as a floor station once; operators then sign in with their name and a 4–6 digit PIN, and it signs them out after 10 idle minutes.
Does it connect to my machines?
Not directly. Time comes from the operators' timers. That covers setup and hands-on work too, which machine monitoring can't see.

Also in Fabber

See it with your own jobs

Set up your shop in an afternoon, or explore a sample shop full of fictional jobs first. 14 days free, no card needed.

Set up your shop